Configuring LAG Settings on a Switch through the Command Line Interface

Interface Range Command Cisco. how to Shutdown All Interface , Save Configuration & reload Cisco The switchport numbering may not always be the same depending on the platforms The Catalyst 2950 series has certain differences with more recent models

In this mode, all entered commands are applied to all interfaces within the range at the time the commands are entered. One such scenario is the introduction of "Interface Range" command in Network switches

Cisco interface range command YouTube

The Interface Range Specification feature is implemented with the interface range command, which causes the device to enter interface range configuration mode The switchport numbering may not always be the same depending on the platforms valid; the command interface range gigabitethernet 1-5 is not valid

Configuring LAG Settings on a Switch through the Command Line Interface. Step 6 end Example: Router(config-if)# end Exits the current configuration mode and returns to One such scenario is the introduction of "Interface Range" command in Network switches

Cisco Only Commands (COC) VLAN global concepts. Instead of configuring each interface separately, this command allows you to define a range of interfaces and apply configurations to all of them at once Apr 25, 2018 Last Updated: Apr 25, 2019 CCNA Study Guide No Comments